SATO GL 4xxe Series Instalační příručka stáhnout pdf (Strana 5)

WLAN Card Installation Guide

Figure 1c. Preparing and installing the WLAN Card

GL4xxe Wireless LAN Card Installation

Before installing the WLAN card, make sure the printer is OFF and disconnected from the

wer supply. Make sure you have discharged any static electricity (by touching a grounded

component on the printer).

Use a Phillips head screwdriver to remove the two

rews that secure the Cover Plate to the Interface

Card slot. Set the plate and screws aside. (Fig 1a)

2. Insert the CF Card into the WLAN Card.

3. Connect the CF Card’s coaxial cable to J2 on the

WLAN Card. (Fig 1b)

Plug the LAN card into the interface slot so that it

snaps into place. Hold the LAN card by the mounting

plate only.

Secure the LAN card with the two screws removed

Step 1.

6. Connect the printer to the AC outlet and to the host

computer with the relevant cables and turn the printer ON.

7. Refer to the Operator’s Manual for the procedure to

configure the LAN settings. A summary of this procedure

reproduced on the following page, but the Operator’s

Manual contains further details in the section on the

Interfaces Mode.

Figure 1a.

Figure 1b.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Žádné komentáře

SATO GL 4xxe Series Instalační příručka Strana 5