SATO CL608VA Návod k obsluze stáhnout pdf (Strana 100)

Continuous Forms Printing

Command Structure None

The printer locates the end of an adhesive label by sensing the

backing between labels or through the use of an eye-mark (black

rectangle on the reverse side of the backing). It locates the end of a

tag from a notch, eye-mark, or a hole between tags. Both sensors

should be disabled when printing continuous forms by placing the

Label Sensor Selection switch (DSW3-3) in the ON position. See

Section 2: Printer Configuration

for instructions on configuring the

printer using the front panel DIP switch array.

If you will be using continuous labels or tags, the printer must be told

to stop feeding in another manner. The length is determined by the

position of the last printed image on the label or tag. The printer will

stop feeding when this last field is finished printing. The length may

be increased with printed spaces (20 hexadecimal) if necessary.

There is no command code to control label length.

Section 4. Programming Reference

Page 4-309001035 Rev. ESATOCL SeriesPrinters

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 255 256

Žádné komentáře

SATO CL608VA Návod k obsluze Strana 100