SATO LP 100R L Instalační příručka Strana 35

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 80
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 34
INSTALLATION GUIDE
21
5.3 Controller Installation, Meto-Logic
1. Open lower Front Door.
2. Locate power strip above main power supply cabinet (see Figure 5-17).
3. Position the Controller in the lower cabinet as shown in Figure 5-15.
4. Connect the monitor AC power cord from the connector panel harness to the Unswitched AC receptacle of
the Printer.
AC Power Strip
Controller
Figure 5-15
!
CAUTION
!
The printer power cord must not be connected until after the controller
has been installed.
!
WARNING
!
Before installation, the Controller power supply voltage selector switch
must be set to the 230V position.
Zobrazit stránku 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Komentáře k této Příručce

Žádné komentáře