SATO LP 100R L Instalační příručka stáhnout pdf (Strana 66)

A P P E N D I X D

D-4

SWING GUIDE INSTALLATION, CONTINUED

11. Swing the front plate upward and secure up against

the bottom frame of the printer against the

stationary magnet.

12. Insert the guide film into the hole in the upper part of

the swing guide (front side).(Figure D-8)

Figure D-8

13. Lower the front plate down to the swing guide

assembly and secure with the two knurled screws.

14. Install the two support plates. (Figure D-9)

Figure D-9

15. Connect the swing guide drive gear assembly with

the one connector. (Figure D-10)

16. Install the cover to the swing guide assembly (front

side) by fastening the two screws.

17. Install the paper guide at 30mm inside from the

paper edge.

Note: When installing the burster unit, redo the

connection of the burster unit.

18. Install the lower-left cover (black) by fastening the

four screws, and close the front door.

SUPPORT PLATES

SCREW SCREW

GUIDE FILM

Figure D-10

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 79 80

Žádné komentáře

SATO LP 100R L Instalační příručka Strana 66